flat panel cabinet doors stiles and rails

FLAT PANEL CABINET DOORS STILES AND RAILS FULL

Rob Johnstone: In truth, I don’t know why there would be a structural difference. If there are a number of intermediate stiles and rails, glue up the innermost pieces first, and work your way outward. Rails: The horizontal elements on the top and bottom of a cabinet door’s center panel. Once the parts are cut, plan your assembly carefully. Panel: The center portion, often a flat slab, of the cabinet door. Same goes with door-building: stiles should cover the ends of rails. Select Oak Drawer Front, Oak Veneered Panel, Rail 1 (2 1/4 wide stiles. This convention, I believe, has more to do with aesthetics - hiding end grain from where it would be most visible (side to side) - than strength. Flat Panel cabinet doors are made with solid wood veneer plywood panels. The ends of any intermediate stiles butt against the rails.

FLAT PANEL CABINET DOORS STILES AND RAILS FULL

Unless you have a really good reason to go against the grain of hundreds of years of tradition, your work will not look “right” unless the stiles continue through the entire vertical dimension.Ĭhris Marshall: The convention for face frames - you could almost call it a rule - is to run the outermost stiles the full length of the frame, then butt the ends of the top and bottom rails against the stiles. In my opinion, though, it is really a matter of design choice and tradition. The rails (the horizontal pieces of the frame) run into the stiles. I agree with you, Ron, that structurally, both constructions probably offer about the same strength. Tim Inman: Typically, the stiles (the vertical parts of the frame) run the entire length. Structurally they are the same, aren’t they? – Ron Bohland What is the proper way to construct/assemble them? Does the rail go inside the stile or does the stile go inside the rail? I have done them both ways, usually because I forget the proper way. I have a question about cabinet face frames.

Flat panel cabinet doors stiles and rails